Posts
Monday, September 28, 2009
So it would seem my missing link was loading the Kona drivers back when I tried to do this. Once loaded then it magically appears in a "direct" deck Read more…
Hello everyone. I'm about to start a project that is being shot on 35mm film. We are doing a one-light transfer to hd dailies, then we will do a best- light Read more…
Multi-cam Masters! The poor assistant didn't know how to group the multi-clips and wound up building selects sequences with a couple of hundred clips and their Read more…
Do it all the time. And it depends on what format the tape is and your purpose. If source is 4:4:4 RGB and the purpose is on-line, then 4:4:4 RGB. If you Read more…
Absolutely. Use ProRes 422. -shane ... [Non-text portions of this message have been removed] Read more…
Hello everyone. Is it possible to capture from HDSR directly into Final Cut through Kona? If so, what would be the recommended project/and capture settings? Read more…
I'm not lazy...I was trying the Keyspan...it just didn't work. Couldn't figure out why. Tried all sorts of cables and nada. But then all I did was install Read more…
I have not followed every word of this thread, but the bottom line is that if you want Kona serial control to work, you simply use the RS422 port that comes Read more…
So what steps did make the Kona serial control work, Exactly. I've tried this before with no success but I didn't hit it hard and I had a keyspan handy. You Read more…
The Adrenaline is fully supported with MC 4.0. Read more…
We run 4.0 on adrenaline mac - fcp on the same system. (that one has no kona card in it, but I'm sure it will work- we occasionally put a mojo Sdi on a system Read more…
Well then, I'll have to give it a try. I really liked the Avid 3.0.5 software on up. 3.1.1 was good. I think asking for 4.0 to work would be too much? Read more…
The problem has been addressed... Jim Read more…
I think they all will after 3.0. ... +++ With best wishes, Roger Shufflebottom Avid Certified Instructor http://www.bottom-line.tv Tel: +44 1992 535 031 (UK) Read more…
Will it work with Adrenaline? The last version I saw compatible with Adrenaline (according to the Avid site) was 3.0. I want to use 3.0.5, so I might test Read more…
Subscribe to:
Posts (Atom)