Hello everyone. I'm about to start a project that is being shot on 35mm film. We are doing a one-light transfer to hd dailies, then we will do a best- light

Re: Avid Adrenaline on FCP system - GREG HUSON!
So it would seem my missing link was loading the Kona drivers back when I tried to do this. Once loaded then it magically appears in a "direct" deck

Re: Avid Adrenaline on FCP system - GREG HUSON!
Well then, I'll have to give it a try. I really liked the Avid 3.0.5 software on up. 3.1.1 was good. I think asking for 4.0 to work would be too much?

Re: Avid Adrenaline on FCP system - GREG HUSON!
We run 4.0 on adrenaline mac - fcp on the same system. (that one has no kona card in it, but I'm sure it will work- we occasionally put a mojo Sdi on a system

MultiClips from Sync Map
Multi-cam Masters! The poor assistant didn't know how to group the multi-clips and wound up building selects sequences with a couple of hundred clips and their

Re: This Sunday :: Sept.27 (12-7) :: "Desi Fashion Show" :: Skylands
The problem has been addressed... Jim

Re: Avid Adrenaline on FCP system - GREG HUSON!
I think they all will after 3.0. ... +++ With best wishes, Roger Shufflebottom Avid Certified Instructor http://www.bottom-line.tv Tel: +44 1992 535 031 (UK)

Re: Avid Adrenaline on FCP system - GREG HUSON!
I have not followed every word of this thread, but the bottom line is that if you want Kona serial control to work, you simply use the RS422 port that comes

Re: Avid Adrenaline on FCP system - GREG HUSON!
I'm not lazy...I was trying the Keyspan...it just didn't work. Couldn't figure out why. Tried all sorts of cables and nada. But then all I did was install

Re: Avid Adrenaline on FCP system - GREG HUSON!
Greg Are you in London? Sent from my dog ... ROOT 6 LIMITED Registered in the UK at 4 WARDOUR MEWS, LONDON W1F 8AJ Company No. 03433253 [Non-text portions of

Re: Avid Adrenaline on FCP system - GREG HUSON!
So what steps did make the Kona serial control work, Exactly. I've tried this before with no success but I didn't hit it hard and I had a keyspan handy. You

Re: Avid Adrenaline on FCP system - GREG HUSON!
The Adrenaline is fully supported with MC 4.0.

Re: Capture from HDSR?
Do it all the time. And it depends on what format the tape is and your purpose. If source is 4:4:4 RGB and the purpose is on-line, then 4:4:4 RGB. If you

Re: Capture from HDSR?
Absolutely. Use ProRes 422. -shane ... [Non-text portions of this message have been removed]

Capture from HDSR?
Hello everyone. Is it possible to capture from HDSR directly into Final Cut through Kona? If so, what would be the recommended project/and capture settings?